2022 Fischer System Manual en i V3.2

Reset the daily information The first menu can be used to reset trip informa tion such as the “trip meter”. Use the “+” button or the “–” button to select “y/yes” or “n/no” on the display. If you select “y”, all daily information will be deleted. Confirm your selection by clicking the “i” button twice in rapid succession. Now the daily information will be set to zero, and you will return to the main view. Select the speed unit The display will offer the possibility to select kilo metres or miles as the display unit. Use the “+” or “–” button to select the desired unit, km/h or mile/h. Confirm your selection by clicking the “i” button twice in rapid succession. You will now re turn to the main view.

CHC Hardware version of the con troller CSC Software version of the controller DHC Hardware version of the display DSC Software version of the display BHC Hardware version of the Battery Management System BSC Software version of the Battery Management System B01 Current temperature of the battery (in °C) B04 Current voltage of the battery (in V) B06 Average power consumption of the system (in A) B07 Usable remaining capacity of the battery (in Ah) B08 Capacity of the battery when fully charged (in Ah) B09 Current battery charge status that can be used by the motor (in %)

D00 Number of battery cells per series connection D01-D13 Voltage of the battery cells per series connection E00-E09 Error code log 13. Assistance level It shows the currently selected support level. The motor support is switched off when no number is shown. 14. Walk Is only shown when the pushing assistance is activated. 15. Information line 16. Service As soon as an inspection of the pedelec becomes due, an appropriate note will flash 3x when the system is switched on. Settings

Do NOT change the settings while riding your pedelec.

Select the support level Navigate with the “i” key to the menu item “CP”. Briefly press the “ ” button. Now the percentage value of the support level flashes. Use the “+” and “–” buttons to change the support level. This allows you to adjust the strength of all support levels one after the other.

B10

Current total charge status of the battery (in %)

This LCD offers you various personalization op tions. To do this, first switch on the display by pressing and holding the “ ” button on the con trol unit for approximately two seconds. Then, quickly press the “i” button twice in a row. You can navigate between the settings by press ing the “i” key. Now you can select the values in the instances where the settings can be modified.

B11 B12 B13

Charge cycle of the battery

Service values Service values

18