2022 Fischer Operating Instructions en V3.2

• Check that the tyre is properly in place and turns straight using the control ring on the side of the tyre. Correct the tyre’s position by hand if it does not turn straight. • Pump air into the tyre up to the recommended pressure.

Both brake rubbers move left

Both brake rubbers move right

• Connect the brake line, attach it or close the brake quick release. • Check whether the brake linings touch the brake surfaces. • Securely attach the brake arm. • Carry out a brake test.

When mounting the wheel, pay at tention to the rotational direction of the tyre.

Brakes

Spring adjust ing screws

Spring adjusting screws

Your pedelec can be equipped with different brake systems. You can find information on the built-in brakes on your pedelec in the enclosed manufacturer’s manual and on the manufac turer’s website.

5. Mounting the wheel Reattach the wheel securely back in the frame or fork with the corresponding quick release, bolted connection or full floating axle mechanism.

Adjusting the brakes on the rim

Source: Shimano ® techdocs

Cantilever brakes

If your pedelec has disc brakes, please ensure that the brake discs are correctly secured between the

V-brake rim brakes

brake pads.

Opening cantilever brake or V-brake • Hold the wheel with one hand.

Read the gear manufacturer‘s in structions to correctly and safely assemble and set up derailleur gear systems, hub gears and combined hub and derailleur gear systems.

• Press the brake arms together against the rim. • Hang the bowden cable of the brake or the out er sheath of the bowden cable over one of the brake arms.

What to do if the rubber brakes start rubbing against the rim: The spring setting allows you to set the return force in such a way that both brake pads lift evenly from the rim when you release the brake lever. Then, check that the brakes are functioning correctly.

Tighten all screws to the recom mended torque Otherwise the screws could break and parts could

fall off (see page 39).

32