2020 EN FISCHER SYSTEM MANUAL
The default setting shows the current speed after switching on the display.
Activating the push assistance
Select motor support You can select the strength of the motor support by pressing the “+” or the “-” button. After switch- ing on the display, level 1 is selected by default.
The pushing aid function works to assist you if you, for example, have to climb a steep ramp from an un- derground car park or underpass. Do not use it to ride the bike. The push assistance is not a start- up support! If you activate your push assistance under a load that is too heavy, your motor will start to jerk or even perform an emergency shut-down! Keep the “-” button pressed to activate the push assistance. The motor supports you by pushing your pedelec at a speed of up to 6m/h. As soon as you let go of the “–” button, the push assis- tance mode is deactivated.
Current speed
Average speed
Motor support level
Watt display The motor power appropriate for the support level selected is also shown in watts.
Maximum speed
Display the total kilometres and the trip counter Press the “MODE” button to switch between “trip meter” (TRIP) and “odometer” (ODO).
Watt display Display of battery charging state
The battery charging state is shown with 5 bars. 5 black bars mean that the battery is fully charged. The battery must be recharged at the latest when no more bar is shown and the frame of the dis- play flashes.
Total kilometres
Trip counter
Reset the trip counter Hold the “MODE” button and the”-” button at the same time until the display is reset to “0”.
Push assistance activated
Battery charting state display
31
Made with FlippingBook Publishing Software