FISCHER SYSTEM MANUAL 2019

6. Unit It shows the measuring unit used to measure speed. 7. Main display It primarily shows the speed. It is used in the menu for navigation and setting purposes. 8. Information line A short press of the “i” button changes to the following displays: • TRIP = Trip counter • TOTAL = Total kilometres • AVG = Average speed • TO GO = Approximate remaining range 9. Information line – Units The appropriate measuring unit for the value displayed in the information line is shown here. 10.Information line – Units 2 The appropriate measuring unit for the value displayed in the information line is shown here. 11.Assistance level It shows the currently selected support level. The motor support is switched off when no number is shown. 12.Walk Is only shown when the pushing assistance is activated. 13.Information line – Values The corresponding value will be shown as a number in the information line, depending on the setting. In addition, there is the “C” information that shows an integer number - indicating the calories approximately used during the current ride.

Display Functional overview

This display only works for pedelecs with a central motor.

1

3 2

14.Service As soon as an inspection of the pedelec becomes due, an appropriate note will flash 3x when the system is switched on. Settings

4 5

14

6

7

8

13

9

10 11

Do NOT change the settings while riding your pedelec.

12

1. Charge status of the battery This shows the current charge status of the battery The battery is empty when only the frame flashes. 2. USB connected This symbol lights up as soon as a USB device has been connected for charging. 3. Illumination activated This symbol lights up as soon as the display lighting and any permanently installed light- ing system have been activated. 4. Error This symbol is shown as soon as an error occurs. An error number is shown on the display at the same time. 5. Menu Only pops up when you are in menu mode.

This LCD offers you various personalization op- tions. First, switch on the display by holding down the “MODE” button on the operating unit.

To get to the settings menu, first switch on your display. Thereafter, quickly press the “i” button twice in a row. The time between the two presses of the “i” button should be at most 0.3 seconds. Reset the daily information The first menu can be used to reset trip informa- tion such as the “trip meter”. Choose “y” using the “+” or “-” buttons in the display. Confirm this with “i”. The trip information is now set to zero.

35