FISCHER OPERATING INSTRUCTIONS

Hand-over documentation

c The assembling/inspecting party completed a test ride c The customer was instructed on how to use the pedelec c Front wheel brake lever on the right c Front wheel brake lever on the left c Instruction on how to fix a flat tyre, how to open and close the fixtures on the driven wheel

The pedelec specified in the “vehicle identification” section was delivered to the customer in the following condition: c A. Fully assembled: ready to ride c B. Pre-assembled: Still to do: Install pedals, straighten, adjust and fix Speedlifter, check and adjust tyre pressure c C. Partly assembled: Still to do: Tighten the pedals and handlebars with the appropriate tools taking into account the correct torque  Only have this assembly work performed by an expert orFischer customer service technician. Check and adjust tyre pressure. Once the pedelec has been handed over to the customer in a properly as- sembled and operational condition, the following applies: It corresponds to model ________ , according to the chapter “Intended use”.

Functional check for the following components: c Wheels: spoke tension, sturdiness, concentricity, correct tyre pressure c All screw joints: secure seating, correct torque (see above: “condition on handover”) c Gear system c Brake system c Bike lights c Adjusting the Sitting Position to the Rider c Suspension adjusted to the rider

Supplied by (retailer stamp):

c The following components were assembled and checked separately: ________________________________________________________ ________________________________________________________

__________ ______________________________________________ Date Signature assembly party/retailer

50