2020 EN FISCHER SYSTEM MANUAL

Error codes

You can mount the control panel on the right or left handlebar. To turn the display, select “Mount- ing side” to open the side selection page.

Error code Error description and solution 24

Error code Error description and solution 01 The charging status is not dis- played correctly. Solution: Contact our service hotline. 08 Error in the transmission of information from an electronic component. Solution: Contact our service hotline. 10 The battery voltage is too low. Solution: Charge the battery. 11 The battery voltage is too high.

The internal voltage is outside the working range. Solution: Charge the battery. Error in the motor current meas- urement Solution: Switch the electrical sys- tem off and on again. If the problem persists, contact our service hotline. A software reset has been carried out. Solution: Switch the electrical sys- tem off and on again. If the problem persists, contact our service hotline. The light is short-circuiting Solution: The light or light cable must be replaced. Contact our service hotline. Detecting overcurrent in the motor Solution: Reducing the strain on the motor by pedalling less or by reduc- ing the support level. Fault in the motor rotation Solution: Switch the electrical sys- tem off and on again. If the problem persists, contact our service hotline. Short circuit in the motor Solution: Switch the electrical sys- tem off and on again. If the problem persists, contact our service hotline.

25

26

Choose the side you prefer and confirm. Chang- ing the mounting side will automatically restart the device. Imperial – Change Unit

31

Solution: Switch the electrical system off and on again. If the problem per- sists, contact our service hotline. The battery is almost or com- pletely discharged. Solution: Charge the battery. Electrical measurements are faulty. Solution: Switch the electrical sys- tem off and on again. If the problem persists, contact our service hotline. Temperature sensor defective Solution: Switch the electrical sys- tem off and on again. If the problem persists, contact our service hotline.

40 / 41

12

20

42

21

43

To change the speed unit from kilometres to miles, click the “Imperial” tick box. All information will be displayed in miles. The change does not require a restart.

21

Made with FlippingBook Publishing Software